We supply a commercial grade wallcovering adhesives designed for contractors. Our adhesives come in different grades suitable for the installation of light to heavy weight textile and vinyl wallcovering with a nonwoven, paper or fabric backing. It has excellent wet adhesion and a generous open time. Vescom Adhesives assures you the maximum quality, clean installation and optimum final results.
Vescom V1000
Vescom 1000 adhesive is intended for the processing of vinyl wallcovering up to 370 g/m².
The adhesive is ready for use but if necessary, can be diluted with a maximum of 4% water.
Before use, stir the adhesive 1000 thoroughly and apply using a short-pile synthetic sheepskin roller. Remove residual adhesive by using clean water and drying afterwards.
For additional information consult the general processing instructions – Vescom vinyl and textile wallcovering. Do not expose adhesive to extreme temperature fluctuations. Vescom adhesive 1000 is frost-resistant up to -10°C.
Vescom V2000
Vescom 2000 adhesive is intended for the processing of textile wallcovering and vinyl wallcovering heavier than 370 g/m².
Depending upon the conditions, such as the temperature and/or condition of the substrate or the specification, the adhesive may be diluted with a maximum of 6% water. Before use, stir the adhesive 2000 thoroughly and apply using a short-pile synthetic sheepskin roller.
Remove residual adhesive on vinyl wallcovering immediately by using clean water and drying afterwards. Ensure that no spots of water or adhesive stain the wallcovering. For further information, consult the general hanging instructions for Vescom vinyl and textile wallcovering. The adhesive must not be exposed to extreme temperature fluctuations. Vescom adhesive 2000 is frost-resistant up to -10°C.
Vescom V3000
Vescom 3000 adhesive is only intended for the processing of vinyl and textile wallcovering on permanently sealed (non-breathing) substrates, for example, pretreated or galvanised metal, plastics and painted substrates. Untreated metal must be pre-treated with an anti-rust solution.
Before use, stir the adhesive 3000 thoroughly, do not dilute and apply using a short-pile synthetic sheepskin roller.
Remove residual adhesive by using clean water and drying afterwards. For additional information consult the general processing instructions – Vescom vinyl and textile wallcovering. Do not expose adhesive to extreme temperature fluctuations. Vescom adhesive 3000 is frost-resistant up to -10°C.